HOW TO INSTALL A REPLACEMENT ON/OFF ROCKER SWITCH
TOOLS NEEDED: 1/4" Nut Driver or Flathead Screwdriver
Shut off power at service entrance before servicing this product.
Open electrical panel by removing the hex screw found at the op of the raceway. Remove bottom hex screw of the raceway found behind the electrical outlet.
Remove the electrical cover from the raceway.
Once inside the raceway, there will be three connectors. Remove all three connectors from terminals of old switch.
Depress the locking springs on old switch and pop switch out through rectangular hole of raceway.
Put the new switch in by coming through the front of the raceway into the rectangular hole with the amber part of the rocker switch pointing towards top of the raceway.
Replace the connector onto the top terminal of the new switch using the white wire connected to the electrical outlet.
Replace the connector onto the side terminal of the new switch using the wire connected to the automatic disconnect switch.
Lastly replace the connector onto the bottom terminal of the new switch using the black wire connected to the electrical outlet.
Replace raceway and screws on top and bottom of raceway. Restore power to unit.