Iron-A-Way

Print this page

REPLACEMENT COVER & PAD

Purchase A Replacement Cover & Pad

Iron-A-Way. Iron Away. IronAway Ironing Board. Iron Away Ironing Center. Ironing Boards. Built In Ironing Centers by Iron Away.

Guided Questionnaire

CALL US TOLL FREE
1-800-536-9495

8am – 4:30pm CT Mon-Fri

HOW TO INSTALL A 50-MINUTE TIMER

TOOLS NEEDED:  1/4" Nut Driver or Flathead Screwdriver, Phillips Screwdriver, and Allen Wrench (supplied.)

NOTE:  For easier installation of your replacement timer, completely remove the electrical cover from the attached electrical raceway.  This is completed by disconnecting the ground wire, and the main electrical supply wire.

Carefully examine how these are wired as you will need to reconnect these wires prior to re-installing your electrical cover.

Step 1

Shut off power at service entrance before rewiring or servicing this product.

Step 2

Open electrical panel by removing the hex screw found at the top of the raceway.

Step 3

Next remove the hex screw found at the bottom of the raceway.

Step 4

Remove the timer knob.  Use the Allen Wrench (supplied) to loosen the set screw.  Gently pry the knob off using a flathead screwdriver.

Step 5

Remove the three 7 x 1/4" Phillips head screws found where the timer knob was removed.

Step 6

Turn the raceway over and remove the three flag connectors from terminals on old timer.

Step 7

Replace the connector onto #3 terminal of the new timer using the 13" long black wire.

Step 8

Replace the connector onto #2 terminal of the new timer using the 6" black wire.

Step 9

Replace the connector onto #7 terminal of the new timer using the 6" white wire.

Step 10

Place shaft of new timer through hole in raceway with the three terminals pointing towards cut-off switch.

Step 11

Turn raceway back over and screw the three 7 x 1/4" Phillips head screws on front of raceway (snug but do not over tighten.)  You may need to align screwholes before inserting screws. 

Step 12

Then replace timer knob on new timer by gently pushing onto shaft.  Use allen wrench to tighten set screw.

Reconnect the ground wire and electrical supply wire prior to re-installing electrical cover.  Replace hex head screws in top and bottom of raceway.  Restore power to unit.

My Cart

Total: $0.00
  • You currently have no items in your cart

Tip Of The Day

Nov, 14 26
It's safe to use sizing or spray starch on a garment as long as it is labeled "machine washable."
View Previous Tips
Copyright © 2009 IRON-A-WAY, Inc. Terms of Use | Privacy Policy | Site Map
Web Design Services by Online Innovative Creations